The reviews are automatic translation.
On 2018-05-23 11:55:30
For stones for stones, the sharpness was good, even with a manual tap it was not necessary to switch back.
Oil is absolutely necessary
On 2018-04-25 16:13:01
There is no problem as long as it is oiled.
However, if you do not turn it, it will break.
Work efficiency UP
On 2018-03-23 21:04:35
We are using it for making threads into stainless steel (SUS 304) through hole.
Previously, I used a hand tap, but this point tap raised working efficiency because cutting waste is discharged in the direction of tool advancement.
On 2017-06-13 16:35:43
Since it is a leading manufacturer, the product is satisfactory as a matter of course It is a pleasure if there is profitable for 5 sets etc.
On 2017-03-06 17:20:47
Used for stainless steel thread cutting. I do not have any complaints.
Stainless steel tapping process
On 2016-07-14 17:43:03
Even if it is somewhat expensive, I chose a product of trust. It is useless if you break up on the way.
Tapping of iron plate
On 2016-02-08 16:07:16
For SUS use, the stop side of the tap gauge has passed. Because it was a noisy job, I used it as it was until the end of its life.
On 2015-12-27 12:50:09
Purchased to make threads on a thick iron plate, originally for stainless steel, I cut the Don Dong mountain without breaking.
Small hole opening of radio control parts
On 2015-07-27 07:43:07
I tried to make an aluminum servo horn by myself and used it for 2 mm thread cutting, the tip was broken and clogged at the second thread cutting. Every recovery I tried to reopen failed and eventually it will not be usable. Since aluminum is fixed to the cutting edge, the mini-milling cutter cut hands to cut off cutting oil carefully so as not to apply unreasonable force, but bought a high tap to cover his immaturity Sorry for this result.
Used for landslides of nuts
On 2015-04-16 18:42:51
You can dress well.