The reviews are automatic translation.
Screw hole repair of rusted auto parts
On 2018-05-02 13:21:30
Special fine pitch is not handled at home center, so we used miltap for general use, so we purchased as much as we needed. Especially it can be used without problems
On 2017-07-19 10:02:01
I searched variously on the net, but I did not find the size I wanted exactly, but it was in monotalou.
On 2017-05-20 16:06:18
M12 × 1.0 was not found in the home center and it was saved by being found in Monotalau
French car maintenance
On 2017-05-17 14:40:49
This size is saved because it is not used in Japan. It is used for correcting the nut and screw fixing the aluminum case
On 2017-05-12 10:56:42
OSG's tap is good with sharpness, I always use it. The price is relatively high, it is a place I always suffer.
Replenishment of missing parts
On 2017-04-12 15:48:03
The usability is better than I thought, the screw was torn off pleasantly.
Tap processing to machine
On 2016-10-23 21:52:12
It is safe OSG made with no problem with this price at this price.
Threading of manufactured products.
On 2014-05-31 11:49:32
I thought that the price was cheap, so I thought that sharpness would be bad. Three pieces were prepared and threaded, but processing was completed with one tap to the end (about 300 holes). Sharpness was good, work finished quickly, it was saved. I also would like to use this manufacturer's tap next.
Hand tapping work
On 2013-01-03 12:37:49
Both precision and finishing condition can be used without problems.
Hand processing of aluminum die-casting
On 2012-07-28 15:42:09
I was worried because it was a thin screw, but it gave me a screw and a thread mountain.