Customer Reviews of Heat Gun High Wind Speed Type No.883-13
The reviews are automatic translation.
Showing 1 - 17 of 17 Reviews
On 2018-04-19 19:37:39
If we used other items cheaper a little more, the resin of the case was weak to heat and soon it was deformed so it did not become usable, so we made it to this manufacturer, there is no problem at the same time for the same use. Attachment was attached, it was sold separately. There are no cases, etc. It is delivered in clear plastic pack.
Shrink film shrinkage work of heat shrinkable tube
On 2018-04-16 15:03:19
Heat shrinkage of shrink film and use for shrinkage work of heat shrinkable tube, shrinkage work is very efficient.
On 2017-03-23 18:44:27
Although it is written as a high wind speed type, the hair dryer is better yet.
Drying of tanks and cleaning parts etc.
On 2016-12-06 15:42:10
I used it for seven years and replaced it this year. It lasts long and is safe.
On 2016-04-22 18:23:06
I am using it without problems. Water repellent processing rain gear etc
Extend the dynoch sheet
On 2016-04-15 17:30:00
It was easy to use, unchanged from what I used before!
Heat shrinkable tube such as harness
On 2016-03-07 19:24:29
Using this high wind speed type is a wonderful wind power that you do not mind using other things
Desorption of bearing (warming of foil)
On 2015-11-27 14:37:49
The wind volume is also strong and easy to use, but if possible display is helpful if possible.
Sheet metal putty drying and bumper - deformation repair
On 2015-07-15 17:14:48
I bought a heater gun of the last time (MHG 1500 in January 5, 2015/01) but the warm wind was broken in the beginning of this month and I bought it I bought this item I hope you are using it before and last long
Pipe bending etc.
On 2015-04-16 19:56:29
Until now I burned using a torch, but it is useful for bending PVC pipes and other plastic products.
Bending of PVC pipe, installation of Teflon tube, etc.
On 2015-04-15 21:31:32
1000 w can be used at high temperature. Previously I used a torch, but I can bend without burning.
On 2015-04-12 20:42:53
I use it for warming Teflon pipe, bending PVC pipe, etc., but it warms up quickly. Even though it consumes 1000 w, you can work with hot wind. It is OK.
Overheating deformation correction of bumper
On 2014-04-05 21:09:15
I think that there is no problem at all
Car service, repair
On 2014-02-28 20:37:52
With this cold weather you can remove the clip smoothly by using a plastic clip detachable heat gun. Warming will not stop working efficiency.
To heat the car film
On 2014-02-10 15:36:22
It's as good as usual, the same as what I used before.
At the time of peeling off the car body sticker etc ....
On 2013-08-30 17:42:14
I used this product for the first time, but I have used more than I thought. As soon as the switch was turned on, it was able to warm up and use it. Someday, I will try using it for bending of vinyl pipe. At that time, I would like to post a feeling of use again.
On 2013-01-21 09:34:57
It can be used without problems. The air volume is also large, so warming is also fast. It is safe because consumable parts can be purchased later as well.
Customers Who Viewed This Item Also Bought