Customer Reviews of goot Solder Wick Wire
The reviews are automatic translation.
Showing 1 - 11 of 11 Reviews
Correction of board
On 2018-07-27 22:26:16
It is used for parts replacement and position correction of board units made in China. Width of 3.5 mm in flat knitting 0.6 mm thick Weaving is loose so width / thickness should be taken as a reference. Since weaving is not done, although semi-sucking is good, twilling is spread, so tweezers are necessary depending on the shape of the sucking part.
When correcting soldering
On 2018-06-13 21:24:43
I used a lot of other manufacturers, but I felt that this suction line was the easiest to suck solder.
This review is about item#39529043.
On 2018-05-02 19:45:54
I've been using goot's products for a long time. I tried variously, but this is the easiest to use. And cheaper than anywhere using category discount!
Foundation repair of home appliances
On 2018-03-31 18:44:17
Eventually I was able to achieve the objective, but I can not absorb the solder well well ... Do you need familiarity?
Creating and repairing printed circuit boards
On 2018-03-26 16:04:37
There are many similar items, but this product is easiest to use. I tried using absorption lines of various manufacturers, but if the line is hard Although absorption of solder was bad or the work did not go forward, this product was Although it is somewhat expensive, absorption is also very good without oxidizing it even if it is not used for a long time.
Maintenance of electronic equipment
On 2017-02-15 11:43:17
Since it will pull off the solder comfortably, there is also a sense of security for removal work of parts that are relatively sensitive to heat.
Suction of solder
On 2017-01-05 15:59:10
It is used for sucking unnecessary solder but the suction power is good and it is very easy to use.
On 2016-11-19 15:33:28
I tried variously, but this is the most easy-to-use price as well.
Suction of extra solder
On 2016-01-13 20:26:32
Since it is discarded after sucking up, the mesh may be even bad.
Finishing and correction
On 2015-10-18 18:32:29
It was a combined purchase for free shipping, but as a store keeps it embarrassing if it is not needed. It is mainly used to correct soldering of surface mount ICs. I chose a wider than usual, but it is saved because it is a cheap price as a try.
Absorption of substrate solder
On 2015-03-24 21:02:17
I procured it because it used to be lost. We suck the most part with solder absorber and use it in finishing. It absorbs with no flux with no problem. Wider width is more efficient in terms of price, but in case of low power soldering iron it may be better to narrow a little more in terms of warming. The soldering iron that we are using is 60W.
Customers Who Viewed This Item Also Bought
10.99 - 89.99 SGD
TAKACHI ELECTRONICS ENCLOSURE
39.99 - 179.99 SGD
549.99 - 999.99 SGD
189.99 - 399.99 SGD
Mitsubishi Hitachi Tool Engineering (former Hitachi Tool Engineering)
91.99 - 759.99 SGD
29.99 - 32.99 SGD